Emil I
This article requires additional modification. The design and/or content of this article do not conform to wiki standards.
|
Emil I
Mouse over "
[Client Values; Actual values in
2,540,000 Cost |
1400280 HP Hit Points |
28.44/2918.85/32 t Weight Limit |
- Commander (Radio Operator, Loader)
- Driver
- Gunner (Loader)
330380 hp Engine Power |
50/16 km/h Speed Limit |
2426 deg/s Traverse |
11.620.16 hp/t Power/Wt Ratio |
NoNo Pivot |
// mm Hull Armor |
180/35/20180/35/20 mm Turret Armor |
AP/APCR/HE
APCR/APCR/HE Shells |
415/4400/325
690/4400/440 Shell Cost |
320/320/420360/360/460 HP Damage |
179/224/53217/242/53 mm Penetration |
r/m ▲
6.27 r/m Magazine-fed Gun ▲
5.45 Rate of Fire Magazine-fed Gun |
▲
Magazine-fed Gun
▼
Magazine-fed Gun
▲
2265.6 Magazine-fed Gun ▲
Magazine-fed Gun
▼
Magazine-fed Gun
▲
2361.6 Damage Per Minute Magazine-fed Gun |
m ▲
0.39 m With 50% Crew: 0.483 m ▲
0.38 Accuracy With 50% Crew: 0.471 m |
s 3.2 s 3.2 Aim time |
2020 deg/s Turret Traverse |
360° Gun Arc |
-12°/+15°-12°/+15° Elevation Arc |
5757 rounds Ammo Capacity |
2020 % Chance of Fire |
m 360 m 360 View Range |
m 710 m 850 Signal Range |
VIII
2540000
The Emil I is a Swedish tier 8 heavy tank.
A variant of the heavy tank developed for the Swedish army under the EMIL project in the 1950s. Design solutions used for the French AMX 13 tank influenced the project, which is obvious from the design of the turret. In 1951, a draft design was prepared, but development was discontinued in favor of later versions.
The Emil I leads to the Emil II.
Modules / Available Equipment and Consumables
Modules
Tier | Engine | Engine Power (hp) |
Chance of Fire on Impact (%) |
Weight (kg) |
Price ()
| |
---|---|---|---|---|---|---|
VII | AOS-895 | 330 | 20 | 765 | 31000 | |
VIII | SFA 8 cyl boxer | 380 | 20 | 800 | 44000 |
Tier | Suspension | Load Limit (т) |
Traverse Speed (gr/sec) |
Rmin | Weight (kg) |
Price ()
| |
---|---|---|---|---|---|---|---|
VII | Emil Alt 1 | 29 | 24 | B/2 | 6360 | 16500 | |
VIII | Emil Alt 2 | 32 | 26 | B/2 | 6360 | 33400 |
Compatible Equipment
Compatible Consumables
Player Opinion
Pros and Cons
Pros:
- Good hull-down capability
Cons:
- Poor armor in the sides and rear
Gallery
Historical Info
The requirements for the proposal made it clear that the vehicle was to be able to function as both an infantry support weapon and a tank destroyer. To make this possible, the tank was to mount a 12cm autoloaded gun. This would allow the tank to firerapidly, it would give it good high-explosive round performance and better performance with HEAT rounds. There were also considerations for subcaliber rounds, but the main ammo types considered were the HEAT and the HE rounds. The idea of a tank sharing the TD and medium roles had been considered before, but only now was such a vehicle possible within the weight limit, set by the Swedish army. The use of an autoloader made it possible to reduce the crew of the tank to 3. The requirements also made it clear that the new tank would need a lot more armor than previous Swedish projects. The main worry was the appearance of the Soviet IS-3 and its 122mm gun. To keep the weight down, the heavier armor of the tank was put on the turret front, here it reached a maximum thickness of 200mm at the gun-mantlet (with 150mm and 125mm sloped armor at the rest of the turret front).
This thick front turret armor was made possible by the use of a protective frontal “shield” instead of the French oscillating turrets, which had the turret split into the upper and the lower section. This also allowed for much better gun depression, that reached a maximum of 14dg. However, the rest of the turret armor was pretty weak with 35mm and 20mm side and rear armor respectively. The hull armor was a bit more interesting. The front had 120mm of armor – but only on the lower plate, the upper plate was better sloped, but only reached 70mm. The greater thickness of the lower plate would also be kept in future revisions of the EMIL project. The rest of the hull armor was really weak with only 20mm side and 30mm rear armor.
Frontal and rear schematics
Perhaps the most interesting thing about the projected tank was its size. The height was only 2,35m, which meant it had lower profile than tanks like the T-44 or IS-3. All in all, the tank was only slightly bigger than the previously projected light tank. This in turn meant that the tank only weighed 28 tons. However, later studies concluded that a vehicle of the performance described in the 1951 proposal would most likely weigh at least 32 tons. The main reason for the small size and low weight was the Swedish military believing that the mobility of a vehicle heavier than 30 tons would be very limited in Swedish terrain. The tank was to be powered by a 550hp air-cooled boxer engine built by SFA, a producer of aircraft engines. This would allow the power to weight ratio of 19,5 hp/t for the 28 ton tank, but with the projected 32 ton weight this would be closer to 17hp/t. The good power to weight ratio also allowed the top speed of 55kph.
Rough size comparison with a T-44
The suspension of the vehicle was based on the Lvkv 42 self-propelled anti-aircraft gun, developed by Bofors. This meant that the tank would have hydraulic springs, that would later be used on the S-tank. Other alternatives were also considered however, such as an interleaved suspension. The hull of the tank was designed by Landsverk, who had been the main Swedish tank manufacturer since the 30′s and the turret was designed by Bofors, who had plenty of experience with guns and turrets for ships and costal defense, but little experience with turrets for actual tanks. The project would continue in 1952, when the fear of the IS-3 would turn the EMIL project into more of a heavy tank project.
Historical Gallery
Historical Accuracy Errata
* The tier 8 Emil as represented in the game is based on the 1951 proposal for a new Swedish 30-tonne tank which had the project name EMIL. Note that nowhere in the original documents is this initial design referred to as Emil 1, instead, it is simply listed as “EMIL”. The name Emil 1 was later used in 1952 for a completely redesigned version of the tank which was a scaled down version of the Emil 2 that you see in game. This Emil 1 had several different armor proposals, none of which are as thick as the in-game Emil 1.
- The Emil was meant to have 14 degrees of gun depression from the front and up to 15 degrees of gun depression at the sides, but in game the tank only has 12 degrees of gun depression.
- The frontal armor in game is thicker than listed in the blueprints
Sources and External Links
Light Tanks | IStrv fm/21 • IIStrv m/38 • IIL-60 • IIIStrv m/40L • IIILago M38 |
Medium Tanks | IVLago • VStrv m/42 • VIStrv m/42-57 Alt A.2 • VIStrv 74 • VIILeo • VIIIStrv 81 • VIIIPrimo Victoria • VIIILansen C • VIIIUDES 14 Alt 5 • IXUDES 16 • XUDES 15/16 |
Heavy Tanks | VIIIEmil I • VIIIEMIL 1951 • VIIIBofors Tornvagn • IXEmil II • IXStrv K • XKranvagn |
Tank Destroyers | IIPvlvv fm/42 • IIIIkv 72 • IVSav m/43 • VIkv 103 • VIIkv 65 Alt II • VIIIkv 90 Typ B • VIIIUDES 03 • VIIIStrv S1 • IXStrv 103-0 • XStrv 103B |
Self-Propelled Artillery |